EPSON L3060 manual

User's Guide Network Settings Making Wi-Fi Settings by Push Button Setup You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions are met, you can set up by using this method. ❏ The access point is compatible with WPS (Wi-Fi Protected Setup). ❏ The current Wi-Fi connection was established by pressing a button on the access point. Note: If you cannot find the button or you are setting up using the software, see the documentation provided with the access point. 1. Hold down the [WPS] button on the access point until the security light flashes. If you do not know where the [WPS] button is, or there are no buttons on the access point, see the documentation provided with your access point for details. 2. Press the seconds). button on the printer until the light and the light flash alternately (approximately 3 The connection setting will start. When a connection is established, the light turns on. Note: light and the light flash simultaneously. After clearing The printer is in a connection error status when the button on the printer, reboot the access point, place it close to the printer and try the printer error by pressing the again. If it still does not work, print a network connection report and check the solution. Related Information & “Checking the Network Connection Status” on page 23 & “Printing a Network Connection Report” on page 23 20