EPSON L3060 manual

User's Guide Network Settings Solutions: Make sure the access point's security type is set to one of the following. If it is not, change the security type on the access point, and then reset the printer's network settings. ❏ WEP-64 bit (40 bit) ❏ WEP-128 bit (104 bit) ❏ WPA PSK (TKIP/AES)* ❏ WPA2 PSK (TKIP/AES)* ❏ WPA (TKIP/AES) ❏ WPA2 (TKIP/AES) * WPA PSK is also known as WPA Personal. WPA2 PSK is also known as WPA2 Personal. E-6 Message: MAC address of your printer may be filtered. Check whether your router/access point has restrictions such as MAC address filtering. See the documentation of the router/access point or contact your network administrator for assistance. Solutions: ❏ Check if MAC address filtering is disabled. If it is enabled, register the printer's MAC address so that it is not filtered. See the documentation provided with the access point for details. You can check the printer's MAC address from the Network Status part on the network connection report. ❏ If your access point is using shared authentication with WEP security, make sure the authentication key and index are correct. Related Information & “Printing a Network Status Sheet” on page 29 E-8 Message: Incorrect IP address is assigned to the printer. Confirm IP address setup of the network device (hub, router, or access point). Contact your network administrator for assistance. Solutions: ❏ Enable DHCP on the access point if the printer’s Obtain IP Address setting is set to Auto. ❏ If the printer’s Obtain IP Address setting is set to Manual, the IP address you manually set is invalid due to out of range (for example: 0.0.0.0). Set a valid IP address from the printer’s control panel or by using Web Config. Related Information & “Printing a Network Status Sheet” on page 29 26