EPSON L380 manual

User's Guide Solving Problems Solving Problems Checking the Printer Status Checking the Error Indicators on the Printer When an error occurs, the light turns on or flashes. Details of the error are displayed on the computer screen. : On : Flashing slowly : Flashing fast Light Situation Solutions No paper is loaded or more than one sheet has been fed at a time. Load paper and press the or button. A paper jam has occurred. Remove the paper and press the button. or Initial ink charging may not be complete. See the Start Here poster to complete initial ink charging. The b light and B light flash alternately. The ink pads need to be replaced. An ink pad is nearing or at the end of its service life. Contact Epson or an authorised Epson service provider to replace the ink pad*. It is not a userserviceable part. When a message saying that you can continue printing is displayed on the computer, press the or button to continue printing. The lights stop flashing for the time being, however, they will continue to flash at regular intervals until the ink pad is replaced. A printer error has occurred. Open the scanner unit and remove any paper or protective material inside the printer. Turn the power off and on again. If the error continues to occur after turning the power off and on again, contact Epson support. The printer has started in recovery mode because the firmware update failed. Follow the steps below to try to update the firmware again. 1. Connect the computer and the printer with a USB cable. 2. Visit your local Epson website for further instructions. 71