EPSON L3060 manual

User's Guide Network Settings E-11 Message: Setup is incomplete. Confirm default gateway setup. Connection using the EpsonNet Setup is available. Contact your network administrator for assistance. Solutions: Check the following. ❏ The default gateway address is correct if you set the printer's TCP/IP Setup setting to Manual. ❏ The device that is set as the default gateway is turned on. Set the correct default gateway address. You can check the default gateway address from the Network Status part on the network connection report. Related Information & “Printing a Network Status Sheet” on page 29 E-12 Message: Confirm the following -Entered security key/password is correct -Index of the security key/password is set to the first number -IP address, subnet mask, or default gateway setup is correct Contact your network administrator for assistance. Solutions: Check the following. ❏ Other devices on the network are turned on. ❏ The network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them manually. ❏ The network addresses for other devices (subnet mask and default gateway) are the same. ❏ The IP address does not conflict with other devices. If still does not connect your printer and network devices after confirming the above, try the following. ❏ Turn off the access point. Wait for about 10 seconds, and then turn it on. ❏ Make network settings again using the installer. You can run it from the following website. http://epson.sn > Setup ❏ You can register several passwords on an access point that uses WEP security type. If several passwords are registered, check if the first registered password is set on the printer. Related Information & “Printing a Network Status Sheet” on page 29 & “Connecting to a Computer” on page 18 28