EPSON L3060 manual

User's Guide Network Settings E-13 Message: Confirm the following -Entered security key/password is correct -Index of the security key/password is set to the first number -Connection and network setup of the PC or other device is correct Contact your network administrator for assistance. Solutions: Check the following. ❏ Network devices such as an access point, hub, and router are turned on. ❏ The TCP/IP Setup for network devices has not been set up manually. (If the printer's TCP/IP Setup is set automatically while the TCP/IP Setup for other network devices is performed manually, the printer's network may differ from the network for other devices.) If it still does not work after checking the above, try the following. ❏ Turn off the access point. Wait for about 10 seconds, and then turn it on. ❏ Make network settings on the computer that is on the same network as the printer using the installer. You can run it from the following website. http://epson.sn > Setup ❏ You can register several passwords on an access point that uses the WEP security type. If several passwords are registered, check if the first registered password is set on the printer. Related Information & “Printing a Network Status Sheet” on page 29 & “Connecting to a Computer” on page 18 Message on the Network Environment Message Solution *Multiple network names (SSID) that match your entered network name (SSID) have been detected. Confirm network name (SSID). The same SSID may be set on several access points. Check the settings on the access points, and change the SSID. The Wi-Fi environment needs to be improved. Turn the wireless router off and then turn it on. If the connection does not improve, see the documentation for the wireless router. After moving the printer closer to the access point and removing any obstacles between them, turn off the access point. Wait for about 10 seconds, and then turn it on. If it still does not connect, see the documentation supplied with the access point. *No more devices can be connected. Disconnect one of the connected devices if you want to add another one. You can simultaneously connect up to four computers and smart devices in Wi-Fi Direct (Simple AP) connection. To add another computer or smart device, disconnect one of the connected devices first. Printing a Network Status Sheet You can check the detailed network information by printing it. 29