Xerox 3270 manual

3270 Programmer’s Guide Manipulation of Temporary and Permanent Memory 3.2. Commands for Storing and Restoring Settings The following commands allow you to manage the temporary and the permanent memory areas. You may save the temporary memory settings in the permanent memory, or you may overwrite the temporary memory settings by loading the settings from the permanent memory or the factory default area. Please note that when one of the commands below are used, the temporary ESC character, if any, will be removed. Command %X1 Description Use this command to save settings permanentlyin the interface memory. Example You send the command as follows: &&??% %X1 Without the %X1, change of settings will be lost at power off. %X3 %X4 Read and activate factory default settings. You send the command as follows: Use this command if you have changed many settings and wish to start all over again. &&??% %X3 Read and activate the permanent settings. You send the command as follows: Use this command if you have changed a couple of settings temporarily for a specific purpose. When you have used the temporary settings, you can erase them again by sending the X4 command. &&??% %X4 - 19 -