Xerox 3270 manual

3270 Programmer’s Guide Introduction In case the converter is equipped with a serial connector, it supports serial input or output. In all three printer drivers, centronics input and output is supported. The 3270 Protocol Converter can be used with most Xerox printers . NOTE: The printer driver must be selected before you start the operation of the device. 1.1. FSL Printer Driver To select the FSL printer driver, see the User’s Guide originally supplied with your product. This printer driver is a user specific printer driver ready for programming. You will have to program the internal setup of the protocol converter to suit your printing requirements. See the FSL 3270 Programmer’s Guide, D62071for further configuration in FSL mode. When to use the FSL driver: • If you need serial output from the converter to connect a printer or other device that needs serial input. • If you want to send printer commands directly to the printer • If a printer without PCL4 or PCL5 emulation should be connected. 1.2. PCL Printer Driver To select the PCL printer driver, see the User’s Guide originally supplied with your product. The default configuration of the converter will suffice for most application programs and uses. You should only change the configuration if you have special requirements. If you should wish to change the configuration, the options may be set from the line as described in this manual. See the PCL 3270 -6-