Ricoh C125 MF manual

10. Troubleshooting Problem Causes Solutions The background of received images appears dirty. Image density is too high. Adjust the image density. See page 162 "Specifying Scan Settings for Scanning". Images from the back of the page appear. Received image is too light. When using moist, rough, or Use the recommended paper. For processed paper, areas of details about the recommended paper, print may not be fully see page 60 "Supported Paper". reproduced. The image density has been specified too low. Increase the image density. For details about how to change the density, see page 118 "Adjusting Image Density". The original of the transmitted fax was printed on paper that is too thin. Ask the sender to reprint the original on thicker paper, and then fax it again. When an Error Is Notified via a Report or E-mail When a report is printed from the machine Error Report An Error Report is printed if a document cannot be successfully sent or received. Possible causes include a problem with the machine or noise on the telephone line. If an error occurs during transmission, resend the original. If an error occurs during reception, ask the sender to resend the document. • If an error happens frequently, contact your service representative. • The "Page" column gives the total number of pages. Power Failure Report • Right after recovery from power failure, the internal battery needs to be sufficiently recharged to guard against future data loss. Keep the machine plugged in and the power on for about 24 hours after the power loss. Even if the power is turned off, the contents of the machine memory (for example, programmed numbers) will not be lost. Lost items will include any fax documents stored in memory using Memory Transmission or Reception. If a file deleted from memory, Power Failure Report is automatically printed as soon as the power is restored. 384