Ricoh C125 MF manual

10. Troubleshooting • If Transmission Error Mail Notification cannot be sent, Transmission Error Report is printed by the machine. Error Code The table below describes the meaning of error codes that appear under "Results" on Fax Journal or transmission status report, and what to do when a particular error code appears. "X" indicates a number in an error code that appear differently depending on the situation. Error Code 1XXX11 Solution An original has been jammed inside the ADF while sending a fax in Immediate Transmission mode. • Remove jammed originals, and then place them again. See page 362 "Paper Feed Problems". • Check the originals are suitable for scanning. See page 74 "Placing Originals". 1XXX21 The line could not be connected correctly. • Check if the telephone line is properly connected to the machine. • Disconnect the telephone line cord from the machine, and connect the cord to a telephone. Check if you can make calls using the telephone. If you cannot make calls this way, contact your telephone company. • If the problem persists, contact your sales or service representative. 1XXX22 to 1XXX23 Dial fails when trying to send faxes. • Check if that the fax number you dialed is correct. • Check if that the destination is a fax machine. • Check if that the line is not busy. • You may need to insert a pause between dial digits. Press [Redial] after, for example, the area code. • Check if [PSTN / PBX] under [Administrator Tools] has been specified properly for your connection method to the telephone network. See page 247 "Administrator Tools Settings". 386