Ricoh C125 MF manual

Transmission Using IPsec Encryption Key Exchange Settings Configuration Flow This section explains the procedure for specifying encryption key exchange settings. Machine PC 1. Set the IPsec settings on Web Image Monitor. 1. Set the same IPsec settings as the machine on PC. 2. Enable IPsec settings. 2. Enable IPsec settings. 3. Confirm IPsec transmission. • After configuring IPsec, you can use "ping" command to check if the connection is established correctly. Because the response is slow during initial key exchange, it may take some time to confirm that transmission has been established. • If you cannot access Web Image Monitor due to IPsec configuration problems, disable IPsec under [Administrator Tools] on the control panel, and then access Web Image Monitor. • For details about disabling IPsec using the control panel, see page 247 "Administrator Tools Settings". Specifying Encryption Key Exchange Settings • This function is available only when an administrator password is specified. 1. Start the web browser and access the machine by entering its IP address. The top page of Web Image Monitor appears. 2. Click [IPsec Settings]. 3. Click the [IPsec Policy List] tab. 4. Select the number of the setting you want to modify in the list. 5. Enter the administrator password, and then click [Change]. 6. Modify the IPsec related settings as necessary. 7. Enter the administrator password, and then click [Apply]. 8. Click the [IPsec Global Settings] tab, and then select [Active] in [IPsec Function]. 9. If necessary, specify [Default Policy], [Broadcast and Multicast Bypass], and [All ICMP Bypass] also. 10. Enter the administrator password, and then click [Apply]. 403