Ricoh C125 MF manual

Transmission Using IPsec 19. In [Description:], enter a name or a detailed explanation of the IP filter, and then click [Next]. You may click [Next] and proceed to the next step without entering any information in this field. 20. Select "My IP Address" in "Source address", and then click [Next]. 21. Select "A specific IP Address or Subnet" in "Destination address", enter the machine's IP address, and then click [Next]. 22. For the IPsec protocol type, select "Any", and then click [Next]. 23. Click [Finish], and then click [OK]. 24. Select the IP filter that you have just created, and then click [Next]. 25. Click [Add...] in the Filter Action. The Filter Action Wizard appears. 26. Click [Next]. 27. In [Name], enter a Filter Action name, and then click [Next]. 28. Select "Negotiate security", and then click [Next]. 29. Select one of options for computers allowed to communicate with, and then click [Next]. 30. Select "Custom" and click [Settings...]. 31. When [ESP] is selected for the machine in [Security Protocol] under [IPsec Settings], select [Data integrity and encryption (ESP)], and configure the following settings: Set the value of [Integrity algorithm] to the same value as the [Authentication Algorithm for ESP] specified on the machine. Set the value of [Encryption algorithm] to the same value as the [Encryption Algorithm for ESP] specified on the machine. 32. When [AH] is selected for the machine in [Security Protocol] under [IPsec Settings], select [Data and address integrity without encryption (AH)], and configure the following settings: Set the value of [Integrity algorithm] to the same value as the [Authentication Algorithm for AH] specified on the machine. Clear the [Data integrity and encryption (ESP)] check box. 33. When [ESP&AH] is selected for the machine in [Security Protocol] under [IPsec Settings], select [Data and address integrity without encryption (AH)], and configure the following settings: Set the value of [Integrity algorithm] under [Data and address integrity without encryption (AH)] to the same value as [Authentication Algorithm for AH] specified on the machine. Set the value of [Encryption algorithm] under [Data integrity and encryption (ESP)] to the same value as [Encryption Algorithm for ESP] specified on the machine. 405