Ricoh C125 MF manual

Error and Status Messages on the Screen Message Cannot Copy This Setting Combine: 2 page on 1 / 4 page on 1 Cannot copy. Set original to ADF. Causes Solutions Combined copying could not be performed because the tray does not contain the valid size paper, which are A4, Letter, or Legal size. • Set the machine to print copies using the A4, Letter, or Legal size paper in the [Select Paper] setting. See page 213 "Copier Settings". Combined copying could not be performed because the originals were not placed in the ADF. • Use the ADF, even when copying a single sheet. • Specify the A4, Letter, or Legal size paper for the tray selected for printing copies. See page 242 "Paper Settings". • If you need to use the exposure glass, select [Off] or [Manual 2Sd Scan Mode] in [Duplex/Combine] under [Copier Settings], and then try again. See page 213 "Copier Settings". Check Paper Size The paper size set for the Press [Continue Printing] to begin printing, document differs from the size of or press [Job Reset] to cancel the job. the paper in the indicated tray. Check Paper Type The paper type set for the document differs from the type of the paper in the indicated tray. Press [Continue Printing] to begin printing, or press [Job Reset] to cancel the job. Connection Failed The line could not be connected correctly. • Confirm that the telephone line is properly connected to the machine. • Disconnect the telephone line from the machine, and connect a standard telephone in its place. Confirm that you can make calls using the telephone. If you cannot make calls this way, contact your telephone company. Cover open A cover is open. Close the cover completely. Density Sensor Require Cleaning The machine failed to adjust color registration. Clean the toner density sensor. See page 328 "Cleaning the Toner Density Sensor". 343