Ricoh C125 MF manual

Error and Status Messages on the Screen Message Causes Solutions Network is not Ready A scanned file could not be sent because the machine has not received IP address information from the DHCP server completely. Wait until the machine receives the IP address information completely, and then try the operation again. On Hook or Stop key The machine has been off-hook for an extended period of time. Put down the handset phone or press the [Clear/Stop] key. Out of Paper: X The indicated tray has run out of paper. Load paper to the indicated tray. See page 46 "Loading Paper". Restarting machine... The machine needs to be restarted. Turn off the power, and then turn it back on. Remove Paper: The machine failed to proceed with the print job, because tray 1 or Tray 2 was specified as the input tray but paper was set in the bypass tray. Remove paper from the bypass tray. Replace Intermediate Transfer Belt The transfer belt is no longer usable, and must be replaced. Contact your sales or service representative. Rpl Rqrd Soon: Print Cart. (X) The print cartridge is almost empty. Prepare a new print cartridge. ReplaceRequiredSoo n:Waste Tnr. Btl. The waste toner bottle needs to be replaced soon. Prepare a new waste toner bottle. Replacement Required: Fusing Unit The fusing unit is no longer usable, and must be replaced. Contact your sales or service representative. Repl Rqrd: Print Cart. (X) The machine has run out of toner. Replace the print cartridge. See page 315 "Replacing the Print Cartridge". Replacement Required:TransferRoll er The transfer roller is no longer usable, and must be replaced. Contact your sales or service representative. RX Communication Error A reception error occurred, and the fax could not be received correctly. If possible, contact the sender of the fax and ask them to resend it. Bypass Tray 347