Ricoh C125 MF manual

10. Troubleshooting Message Causes Solutions Scan (NW) Disconnected A scanned file could not be sent because the Ethernet cable was not connected properly. Reconnect the Ethernet cable properly, and then try the operation again. Scan (USB) Disconnected The USB cable was disconnected while scanning from a computer. Reconnect the USB cable properly, and then try the operation again. Server Connection Failed A scanned file could not be sent because the destination could not be reached. Confirm that the destination is registered correctly, and then try the operation again. Server Response Error An error occurred in communication with the server before beginning transmission. Confirm that the destination is registered correctly, and then try the operation again. If the problem could not be solved, contact the network administrator. SCXXX A fatal hardware error has occurred, and the machine cannot function. Contact your sales or service representative. Set Correct Paper The tray selected in [Select Paper Tray] under [Fax Settings] does not contain A4, Letter, or Legal size paper. While the message is displayed, press [Set Size]. A menu for changing the paper size of the current tray appears. Load A4/Letter/ Legal size paper in the tray, and then select the corresponding paper size. Note that the paper size setting for the tray under [Paper Settings] will be changed. See page 242 "Paper Settings". Set Original to ADF Cannot use exposure glass with set. in [Scan Size]. 348 Scanning could not be performed because the originals were not placed in the ADF, even though the machine is set to scan originals larger than A4/Letter size. • Use the ADF, even when scanning A4/Letter or smaller size originals. • If you need to use the exposure glass, set A4/Letter or smaller size in [Scan Size...] under [Scan Settings], and then try again. See page 162 "Specifying Scan Settings for Scanning".